7K • Chapter 7
7-20
Enable/Disable ID Messages During Autopatch
Allows the Identifier to operate during an autopatch and reverse
patch.
• Enter this command to allow the identifier to operate during an autopatch.
• Enter one digit, 0 for OFF (disabled), 1 for ON (enabled).
• By default, the identifier is disabled during an autopatch.
• This command has no effect if executed during an autopatch. This
command will take effect on the next autopatch.
Command Form:
Command Form Data Digits
Enable/Disable ID During Autopatch (PW) 63 09 x * 0 = OFF (disabled)
1 = ON (enabled)
Acknowledgment: Sends OK
Errors:
Error Meaning
? err 1 wrong number of digits entered
? err 2 illegal digit entered
Default Condition: Disabled.
Example:
To enable the identifier during a patch, enter the following:
(PW) 63 09 1 *
To disable the identifier during a patch, enter the following:
(PW) 63 09 0 *
To Next Page
Loading...