7K • Chapter 13
13-2
Enable/Disable Path
Enables or disables the various Paths 1 through 11.
• Path 1 connects Receiver 1 to Transmitter 1.
• Path 2 connects Receiver 2 to Transmitter 1.
• Path 3 connects Receiver 3 to Transmitter 1.
• Path 4 connects Receiver 1 to Transmitter 2.
• Path 5 connects Receiver 2 to Transmitter 2.
• Path 6 connects Receiver 3 to Transmitter 2.
• Path 7 connects Receiver 1 to Autopatch/Reverse Patch.
• Path 8 connects Receiver 2 to Autopatch/Reverse Patch.
• Path 9 connects Receiver 3 to Autopatch/Reverse Patch.
• Path 10 connects Autopatch/Reverse Patch to Transmitter 1.
• Path 11 connects Autopatch/Reverse Patch to Transmitter 2.
• Paths enabled during Phone Line Control Mode use the Monitor/Talk Out
Via Phone command described on page 7-45.
Command Form:
Command Form Default
Enable/Disable Path 1 (Rx1 to Tx1) (PW) 63 81 x * ON (enabled)
Enable/Disable Path 2 (Rx2 to Tx1) (PW) 63 82 x * ON (enabled)
Enable/Disable Path 3 (Rx3 to Tx1) (PW) 63 83 x * ON (enabled)
Enable/Disable Path 4 (Rx1 to Tx2) (PW) 63 84 x * ON (enabled)
Enable/Disable Path 5 (Rx2 to Tx2) (PW) 63 85 x * ON (enabled)
Enable/Disable Path 6 (Rx3 to Tx2) (PW) 63 86 x * ON (enabled)
Enable/Disable Path 7 (Rx1 to AP) (PW) 63 87 x * ON (enabled)
Enable/Disable Path 8 (Rx2 to AP) (PW) 63 88 x * OFF (disabled)
Enable/Disable Path 9 (Rx3 to AP) (PW) 63 89 x * OFF (disabled)
Enable/Disable Path 10 (AP to Tx1) (PW) 63 90 x * ON (enabled)
Enable/Disable Path 11 (AP to Tx2) (PW) 63 91 x * OFF (disabled)
Data Digit:
Digit Meaning
0 OFF (disabled)
1 ON (enabled)
Acknowledgment: Sends OK
Errors:
Error Meaning
? err 1 wrong number of digits entered
? err 2 illegal digit entered
To Next Page
Loading...