7K • Chapter 17
17-8
Enable/Disable Transmitter
Enables or disables the specified Transmitter (TX1 or TX2) while
not affecting receiver functions.
• The receiver will still be able to send commands to the controller, but the
transmitter will not be keyed upon receiving COR signals.
• See the various Key Transmitter commands beginning on page 17-9.
Command Form:
Command Form Data Digit
Enable/Disable Transmitter 1 (PW) 63 00 x * 0 = OFF (disabled)
1 = ON (enabled)
Enable/Disable Transmitter 2 (PW) 63 22 x * 0 = OFF (disabled)
1 = ON (enabled)
Acknowledgment: None
Errors:
Error Meaning
? err 1 wrong number of digits entered (disable only)
? err 2 illegal digit entered (disable only)
Default Condition: Both Transmitters TX1 and TX2 are ON (enabled)
To Next Page
Loading...