Remote Base Interface
21-7
Reset RBI-1
Perform a hardware reset of the RBI-1 and the attached remote
base radios.
• This command performs a reset of the RBI-1 and attached remote base
radios.
• The RBI-1 Reset output (7K J3-16) is pulsed to hard-reset the RBI-1.
• After the Reset occurs, the previous radio settings are sent to the RBI-1.
• This command may take several seconds to complete.
Command Form:
Command Form
Reset RBI-1 (PW) 39 91 *
Acknowledgment: Sends OK
Errors:
Error Meaning
? err 1 wrong number of digits entered
Default Condition: None.
Example:
To reset the RBI-1 and attached radios, enter the following:
(PW) 39 91 *
To Next Page
Loading...