Macros
6-7
Append To Macro
This command is used to attach additional commands to a macro.
• The macro name (to be appended) must already exist in the directory.
• The stored information, shown below as Command, in the command form
section, may be a control command or another macro name (if you wish to
chain together several macros).
Command Form:
Command Form
Append to Macro (PW) 29 (macro name, command)*
Acknowledgment: Sends OK
Errors:
Error Meaning
? err 1 too few digits entered
? not found macro name does not exist in directory
? too big command being entered exceeds the storage
area remaining for this macro
Default: None
Examples:
Assume that a macro has been created to turn ON Logic Output #1, and that
its name is 6A. We wish to append a command that dials a telephone number
(i.e. accesses the autopatch). This way, entering 6A will result in the controller
both dialing the number and turning on the output.
Assuming the autopatch password is 10 (the default), and the number we wish
to dial is 663-6000, the command to dial is:
(PW) 29 006A 10 6636000 *
Note: The macro 6A must already exist before this additional command may
be appended. See the Create New Macro command on page 6-5.
To Next Page
Loading...