Macros
6-9
List Macro
Examines the contents of a macro and sends it in either CW or
speech.
• Entering one of these commands causes the controller to send all stored
digits in CW or speech. In CW the (*) character is sent as a fraction bar (/);
in speech, the (*) character is sent as the word “enter”.
• The macro name must be entered using 4 digits.
• If the macro you wish to list has a shorter name, enter leading zeros.
Command Form:
Command Form
List Macro in CW (PW) 33 (macro name) *
List Macro in Speech (PW) 35 (macro name) *
Acknowledgment: Sends the contents of the macro in CW or speech.
Errors:
Error Meaning
? err 1 wrong number of digits entered
? not found macro name does not exist in the directory
Default Condition: None.
Example:
Assume that a macro exists with the name 6A. It contains two commands as
discussed in the Create New Macro and Append To Macro commands (see
pages 6-5 and 6-7). To make the example clearer, assume that the password
is 99.
When the commands were originally placed into the macro, they looked like
this:
(PW) 70 1 * and 10 663 6000 *
To examine this macro in CW, we would enter:
(PW) 33 006A *
The controller would then send:
99701/106636000/
To Next Page
Loading...