S-COM 7K - Select Autopatch Receiver-Specific Access-Triggered Macros

Telephone Interface Functions
7-67
Select Autopatch Receiver-Specific Access-Triggered
Macros
Assigns macros to be executed upon accessing the autopatch from
a specific receiver.
• Each receiver can be assigned its own access-triggered macro.
• If a macro is not assigned for a specific receiver, the default
access-triggered macro is executed (see page 7-10).
• Enter the password, the 4-digit root number, and the 4-digit name of the
macro you wish to have executed at the transition, and the (*).
• If the macro name has fewer than 4 digits, enter leading zeros.
• If you wish to prevent a macro from being executed that was previously
assigned, enter just the password, the 4-digit root number, and the (*).
Command Form:
Command Form
Assign Rx1 Autopatch Access-Triggered
Macro
(PW) 26 75 (macro name) *
Assign Rx2 Autopatch Access-Triggered
Macro
(PW) 26 76 (macro name) *
Assign Rx3 Autopatch Access-Triggered
Macro
(PW) 26 77 (macro name) *
Acknowledgment: Sends OK
Errors:
Error Meaning
? err 1 wrong number of digits entered
? err 2 illegal digit entered
Default Condition: No macros assigned.