7K • Chapter 7
7-32
Change Autopatch Access Password
Replaces the old Autopatch Access Password with a new one.
• The password refered to in this commandis the Autopatch Access
Password. It is different from both the Master and Control Operator
Passwords. It is only used to access the autopatch and not to modify
control functions.
• New autopatch access password is a 2, 4 or 6 digit number of any
combination of
0–9 and A–D.
Command Form:
Command Form
Change Autopatch Access Password (PW) 23 (new Autopatch Access Password) *
Acknowledgment: Sends OK
Errors:
Error Meaning
? err 1 wrong number of digits entered
Default Condition: Autopatch Access Password is set to 10.
Examples:
Assume that the autopatch access password is 10, and that you wish it
changed to A5. Enter the following command:
(PW) 23 A5 *
Note: This will prevent users without 16-button DTMF pads from accessing the
autopatch.
Now assume that the autopatch access password is to be changed again, this
time to 6146. Enter the following command:
(PW) 23 6146 *
To Next Page
Loading...