Telephone Interface Functions
7-33
Enable/Disable Autopatch Access Without Password
Allows the autopatch to be accessed without using the Autopatch
Access Password.
• The autopatch can be accessed in two ways—with—or without an
autopatch access password.
• To access the autopatch without using the autopatch access password, this
command must be ON (enabled).
• Enter one digit, 0 for OFF (disabled), 1 for ON (enabled).
Command Form:
Command Form Data Digit
Enable/Disable Autopatch Access Without
Password
(PW) 63 11 x * 0 = OFF (disabled)
1 = ON (enabled)
Acknowledgment: Sends OK
Errors:
Error Meaning
? err 1 wrong number of digits entered
? err 2 illegal digit entered
Default Condition: Defaults to OFF (cold start); Retained (warm start)
Examples:
Assume that the Enable/Disable Autopatch Access Without Password feature
is OFF (disabled), and you wish to turn it ON (enabled). Enter the following:
(PW) 63 11 1 *
If you wish to turn the feature OFF, enter the following:
(PW) 63 11 0 *
To Next Page
Loading...