7K • Chapter 7
7-40
Clear (or Enter) Accepted Number Table
Clears ALL accepted numbers from the Accepted Number Table—
or—enters an accepted number into same.
• The Accepted Number Table exists only in the controller’s memory. As
such, there is no printing of it in this manual.
• Up to 40 entries are permitted.
• One phone number up to 18 digits long may be entered in each command.
• The phone number may be a specific number or it may contain the “A”
character as a wild card.
• To clear the Accepted Number Table, enter nothing after the 68 root
number.
• To insert the phone number into the Accepted Number Table, enter the
phone number after the 68.
Command Form:
Command Form
Clear All Accepted Numbers From Table (PW) 68 *
Enter Accepted Number Into Table (PW) 68 (phone number) *
Acknowledgment: Sends OK
Errors:
Error Meaning
? err 1 too many digits entered (more than 18)
? err 2 illegal character entered (B, C, or D)
? full table is full
Default Condition: Accepted Number Table is empty
Examples
Two telephone numbers, 911 and 234-5678, are to be accepted numbers. To
add them to the Accepted Number Table, enter the following:
(PW) 68 911 *
(PW) 68 234 5678 *
To Next Page
Loading...