7K • Chapter 7
7-18
Enable/Disable Autopatch Privacy
Turns the Autopatch Privacy feature ON or OFF.
• When ON (enabled), the audio from the repeater receiver is not transmitted
(repeated) during an autopatch.
• When OFF (disabled), the audio is transmitted (repeated) similarly to the
normal operation of the repeater.
• Enter one digit, 0 for OFF (disabled), 1 for ON (enabled).
Command Form:
Command Form Data Digit
Enable/Disable Autopatch Privacy (PW) 63 06 x * 0 = OFF (disabled)
1 = ON (enabled)
Acknowledgment: Sends OK
Errors:
Error Meaning
? err 1 wrong number of digits entered
? err 2 illegal digit entered
Default Condition: Autopatch Privacy is OFF (disabled)
Examples:
This feature is temporary and remains in effect for the duration of only one
autopatch call. At the end of the call it is automatically turned OFF. This
command can be placed in a macro with the Access Autopatch commands
(beginning on page 7-28), thus making that macro a “privacy speed dial.”
It is important for control operators to ensure that amateur autopatches do not
involve business calls. This should be considered when allowing the use of the
Enable/Disable Autopatch Privacy, as the content of the conversation is not
easily determined by control operators.
To Next Page
Loading...