S-COM 7K - Select Receiver-to-Autopatch-Triggered Macros

7K • Chapter 7
7-22
Select Receiver-to-Autopatch-Triggered Macros
Allows the programmer to execute macros based on receiver-to-
autopatch activity.
• Macros can be executed based on receiver-to-autopatch activity.
• Enter the password, the 4-digit root number, and the 4-digit name of the
macro you wish to have executed at the transition, and the (*).
• If the macro name has fewer than 4 digits, enter leading zeros.
• If you wish to prevent a macro from being executed that was previously
assigned, enter just the password, the 4-digit root number, and the (*).
Command Form:
Command Form
Assign Macro to Any-Receiver-Active to
Autopatch
(PW) 26 06 (macro name) *
Assign Macro to All-Receivers-Inactive to
Autopatch
(PW) 26 07 (macro name) *
Acknowledgment: Sends OK
Errors:
Error Meaning
? err 1 wrong number of digits entered
? err 2 illegal digit entered
Default Condition: No macros assigned.