7K • Chapter 7
7-10
Enable/Disable Autopatch Dialing Mixed-Mode
Controls whether mixed-mode dialing is allowed on the autopatch.
• Mixed-Mode dialing means both rotary and DTMF dialing are allowed.
• The dialer will dial only in the way allowed by the Select Autopatch Dialing
Mode command on page 7-6.
• If mixed-mode dialing is turned OFF (disabled), the controller will ignore any
C and D characters in the phone number. (C means dial in rotary, D means
dial in DTMF.)
• If mixed-mode dialing is turned ON (enabled), the dialer will switch back and
forth between rotary and DTMF dialing, according to C and D characters
found in the telephone number.
• Enter one digit, 0 for OFF (disabled), 1 for ON (enabled).
Command Form:
Command Form Data Digit
Enable/Disable Autopatch Dialing Mixed-
Mode
(PW) 63 04 x * 0 = OFF (disabled)
1 = ON (enabled)
Acknowledgment: Sends OK
Errors:
Error Meaning
? err 1 wrong number of digits entered
? err 2 illegal digit entered
Default Condition: Autopatch Dialing Mixed-Mode Is OFF (disabled)
To Next Page
Loading...