7K • Chapter 4
4-44
Select/Review Command Response Messages
Selects, changes, or reviews command response messages that
are sent when command responses are enabled.
• Enter the password, followed by the 4-digit root number shown, followed by
the desired message.
• Any message may have any combination of message types, including CW,
beeps, page tones, speech, etc.
• The maximum size of any message is 50 bytes (50 2-digit codes).
• You must count the control character. Therefore, any message could have
46 CW characters, 23 synthesized speech words, etc.
• To delete a message, enter the password, the 4-digit root number, and the
(*) (do not enter any message).
Command Form:
Command Form Default
Select OK Command Response Message (PW) 31 01 (message) * OK in CW
Select Error 1 Command Response
Message
(PW) 31 02 (message) * ?ERR1 in CW
Select Error 2 Command Response
Message
(PW) 31 03 (message) * ?ERR2 in CW
Review OK Command Response Message (PW) 34 01 * none
Review Error 1 Command Response
Message
(PW) 34 02 * none
Review Error 1 Command Response
Message
(PW) 34 03 * none
Acknowledgment: Sends OK
Errors:
Error Meaning
? err 1 wrong number of digits entered
? err 2 illegal digit entered
Default Condition: See default column of table.
To Next Page
Loading...