7K • Chapter 18
18-2
Select Repeater Access Mode (Path 1)
Selects one of seven possible Access Modes for Path 1.
• Enter one digit from the Repeater Access Mode Table below.
Command Form:
Command Form Data Digit (Mode)
Select Repeater Access Mode (Path 1) (PW) 57 00 x * Repeater Access
Mode Table (below)
Mode Repeater Access Explanation
0 No Access Activity on the COR and PL inputs is ignored.
1 Carrier Access Activity on the COR input will key the
transmitter; activity on the PL input is ignored.
2 PL Access Activity on the PL input will key the transmitter;
activity on the COR input is ignored.
3 And-PL Access Activity on both the COR and PL inputs
simultaneously will key the transmitter.
4 Or-PL Access Activity on either the COR or PL inputs will key
the transmitter.
5 Anti-PL Access Activity on the COR input simultaneously with
no activity on the PL input will key the
transmitter.
6 Always Access Activity on the COR and PL inputs is ignored.
The path is always enabled.
Acknowledgment: Sends OK
Errors:
Error Meaning
? err 1 wrong number of digits entered
? err 2 illegal digit entered
Default Condition: Access Mode for Path 1 is Mode 1 (Carrier Access)
Note: Repeater access mode may be made different from DTMF decoder
access mode, if desired. (See page 11-5.)
To Next Page
Loading...