S-COM 7K - Command: Select Autopatch Dialing Mode

7K • Chapter 7
7-6
Select Autopatch Dialing Mode
Programs the type of autopatch dialing.
• Enter one digit representing the dialing mode from the table below.
Command Form:
Command Form Data Digit
Select Autopatch Dialing Mode (PW) 61 x * 1 = 10 PPS
2 = 20 PPS
3 = DTMF
Data Digit Explanation
1 10 pulses per second, rotary dialing
2 20 pulses per second, rotary dialing
3 DTMF (Touch Tone™) dialing
(5 digits per second)
Acknowledgment: Sends OK
Errors:
Error Meaning
? err 1 wrong number of digits entered
? err 2 illegal digit entered
Default Condition: Autopatch Dialing Mode is 10 PPS rotary
Examples:
To change the dialing mode to 20 pulses per second, enter the following:
(PW) 61 2 *
To change the dialing mode to DTMF (Touch Tone™), enter the following:
(PW) 61 3 *