Remote Base Interface
21-25
User Function: Enable/Disable CTCSS Encoder
Enables or disables the CTCSS Encoder on the currently active
remote base radio.
• The CTCSS Encoder can be enabled or disabled.
• This command has no effect if a memory channel of the currently active
radio is selected and the memory channel enables the CTCSS Encoder.
Command Form:
Command Form
Enable/Disable CTCSS Encoder (RBPW) 48 x *
0 = OFF (disable)
1 = ON (enable)
Macro: Select Enable/Disable CTCSS
Encoder
(Stored until (RBPW) 39 sent.)
(RBPW) 28 x *
Acknowledgment: Sends OK
Errors:
Error Meaning
OFF remote base is disabled
? err 1 wrong number of digits entered
? err 2 illegal digit entered
Default Condition: The CTCSS Encoder is enabled when a CTCSS frequency
is selected. The CTCSS Encoder is disabled when a VFO frequency is
selected.
Example:
To enable the CTCSS Encoder in the selected radio, enter the following:
(RBPW) 48 1 *
To disable the CTCSS Encoder in the selected radio, enter the following:
(RBPW) 48 0 *
To Next Page
Loading...