Telephone Interface Functions
7-7
Select (Review) Autopatch Dialing Message
This message is sent over the repeater transmitter when the
controller starts to dial the autopatch telephone number.
• Lets a user know the autopatch command was entered correctly.
Otherwise, a delay before ringing (especially when rotary dialing) may
convince the user that a call was rejected.
Command Form:
Command Form
Select Autopatch Dialing Message (PW) 31 40 (message) *
Review Autopatch Dialing Message (PW) 34 40 (message) *
Acknowledgment: Sends OK
Errors:
Error Meaning
? err 1 wrong number of digits entered
? err 2 illegal digit entered
Default Condition: Sends AS (wait) in CW
To Next Page
Loading...