S-COM 7K - Select (Review) Programmable Tail Messages for Tx1

Identifier
12-9
Select (Review) Programmable
Tail Messages for Tx1
Defines the Initial and Normal ID Programmable Tail Messages for
Tx1.
• A Tail Message is sent immediately after its associated ID Message.
• Tail Messages provide a simple way to turn on and off a supplemental
message using the Select (Review) Initial and Normal ID Tail Messages
Command (see page 12-11).
• Any Programmable Tail Message may be a combination of message types
including CW, beeps, page tones, speech, etc.
• The maximum size of any message is 50 bytes (50 2-digit codes). You
must count the control characters. Therefore, any message could have 46
CW characters, 23 synthesized speech words, etc.
• To delete a message, enter the password, the 4-digit root number, and the
(*); do not enter any message.
• This command only establishes the contents of the programmable
message. Use the Select (Review) Initial and Normal ID Tail Messages
Command (see page 12-11) to enable the message.
Command Form:
Command Form Default
Select Initial ID Programmable Tail Message
for TX1
(PW) 31 28 (message) * none
Select Normal ID Programmable Tail
Message for TX1
(PW) 31 29 (message) * none
Review Initial ID Programmable Tail
Message for TX1
(PW) 34 28 * none
Review Normal ID Programmable Tail
Message for TX1
(PW) 34 29 * none
Acknowledgment: Sends OK
Errors:
Error Meaning
? err 1 wrong number of digits entered
? err 2 illegal digit entered
Default Condition: No message is programmed.
Example:
To program the Initial ID Programmable Tail Message for TX1 to say “Net at 8 PM”,
enter the command:
(PW) 31 28 9960 0331 0039 0129 0369 0287 *