7K • Chapter 7
7-14
Example 1:
If you have your autopatch plugged into an extension on a PBX and need to
dial 9 to get an outside line, enter the following:
(PW) 83 10 09 16 * ; dial 9, 1-second pause
Example 2:
If you want outgoing calls from your autopatch to block your phone number
from a Caller ID display unit, enter the following:
(PW) 83 10 14 06 07 16 * ; dial *67, 1-second pause
Example 3:
If you want to set up your autopatch to dial an outside line on a PBX by default,
but still want to be able to dial other extensions on the PBX, you can set the
default prefix in your Autopatch Dump-Triggered Macro (see page 7-16) by
entering:
(PW) 83 10 09 16 * ; dial 9, 1-second pause
This way your default Dialing Prefix is always reset after every call.
Then, create a macro that you dial before making a call to an extension on the
PBX. Create a macro by entering:
(PW) 20 0001 (PW) 83 10 * ; clear prefix
To make a call to an extension, enter:
1 * (APW) (extension number) *
For this example, assume your Autopatch Password is 10 and you are dialing
an extension of 123, then you would enter:
1*10123*
When you dump the call, the Autopatch Dump-Triggered Macro will reset the
Dialing Prefix to the default.
To Next Page
Loading...