Telephone Interface Functions
7-43
Note: Only the phone number goes into the table, not the autopatch access
password plus the phone number. Two command entries are needed, since
only one phone number may be entered at a time.
Now assume that all numbers in the 246 exchange are to be rejected. To
accomplish this, enter the following:
(PW) 67 246 AAAA *
The “A” is used as a wild card to specify any number 0–9 is rejected. After this
command is entered, the autopatch will reject any call to a 7-digit number with
246 exchange (246-0000) through (246-9999).
To Next Page
Loading...