Receiver Functions
16-3
Errors:
Error Meaning
? err 1 wrong number of digits entered
? err 2 illegal digit entered
Default Condition: No macros are assigned; Timers are 1.0 minute
Examples:
These macros execute based solely on receiver activity, and act independently
of the transmitter paths that the receivers drive. The setting of the
corresponding receiver path to Tx1 determines when there is receiver activity
even if the corresponding path is not enabled.
If Receiver 2 is a link receiver, for example, the link can be “knocked down”
(disabled) after several minutes of link inactivity.
These receiver-driven macros should not be confused with the Repeater
Activity-Triggered Macro feature, which requires that Path 1 (Receiver 1 to
Transmitter 1) be enabled. See the Enable/Disable Path 1 (RX1 to TX1)
command on page 13-2.
To Next Page
Loading...