7K • Appendix B
B-2
Place two commands into each macro; the first one is a Send Message
command (page 4-42) that has one of the desired callsigns in it, and the
second one reprograms the impolite ID macro using the Select Impolite ID
Macro command (page 12-4):
(PW) 20 1000 (PW) 15 (CW message #1) *
(PW) 29 1000 (PW) 26 05 1001 *
(PW) 20 1001 (PW) 15 (CW message #2) *
(PW) 29 1001 (PW) 26 05 1002 *
Continue building macros 1002, 1003, and 1004. At macro 1004 reprogram the
Select Impolite ID Macro command back to 1000:
(PW) 20 1004 (PW) 15 (CW message #5) *
(PW) 29 1004 (PW) 26 05 1000 *
Don't forget to program the Select Impolite ID Macro command (page 12-4) to
get the chain started:
(PW) 26 05 1000 *
You’ll also want to suppress the Enable/Disable Command Response
Messages command (see page 11-2) to keep from hearing OK each time a
macro is executed.
To Next Page
Loading...