Messages
4-15
Errors:
Error Meaning
? err 1 wrong number of digits entered
? err 2 illegal digit entered
Default Condition:
Command Default Condition
Select Normal CW Speed 20 WPM
Select Slow CW Speed 15 WPM
Examples:
To change the normal CW sending speed to 17 words per minute, enter:
(PW) 12 5 *
To change the slow CW sending speed to 10 words per minute, enter:
(PW) 13 2 *
Note: There are two ways to change the speed of a CW message. One way is
to use the commands shown above; this is usually done upon installation. The
other method is to insert a speed change character into the message. The
latter is a temporary method, since the speed returns to normal after the
message is sent.
To Next Page
Loading...