S-COM 7K - Page 9

Table of Contents
ix
Command: Select (Review) Reverse Patch Ringout Message ...............................................7-62
Command: Select Reverse Patch Ring-Triggered Macro .......................................................7-63
Multiple Port Access ............................................................................................................ 7-64
Autopatch Audio Routing ........................................................................................................ 7-65
Autopatch Command Response Message Routing ............................................................... 7-65
Receiver-Specific Autopatch Access ...................................................................................... 7-66
Preventing Multiple Accesses ................................................................................................. 7-66
Command: Select Receiver-Specific Access-Triggered Macros .............................................7-67
Command: Select Command Response Message Routing ....................................................7-68
Clock and Calendar ........................................... 8-1
Command: Set Clock and Calendar ..........................................................................................8-2
Command: Adjust Daylight Savings Time .................................................................................8-4
Command: Reset Clock Seconds .............................................................................................8-6
Command: Adjust Clock Seconds .............................................................................................8-7
Scheduler ........................................................... 9-1
Command: Create Setpoint .......................................................................................................9-2
Scheduler Day Code Table ....................................................................................................... 9-3
Command: Delete One or More Setpoints ................................................................................9-6
Command: Enable/Disable Scheduler ......................................................................................9-7
CTCSS Functions ............................................ 10-1
Command: Enable/Disable CTCSS Encoder ..........................................................................10-2
Command: Select Frequency of CTCSS .................................................................................10-3
TS-32 Programming Table ..................................................................................................... 10-4
DTMF Decoder ................................................. 11-1
Command: Enable/Disable Command Response Messages .................................................11-2
Command: Select DTMF Priority/Scan ...................................................................................11-3
Command: Select DTMF Decoder Access Mode ...................................................................11-5
Command: Select DTMF Decoder Interdigit Timer .................................................................11-7
Command: Select DTMF Decoder Mute Delay .......................................................................11-8
Command: Enable/Disable DTMF Decoder Mute ...................................................................11-9
Command: Enable/Disable DTMF Long Tones .....................................................................11-10
Command: Select DTMF Long Tone Macros ........................................................................11-11
Command: Select DTMF Digit-Decoded Macro ....................................................................11-12
Identifier ........................................................... 12-1
Command: Select (or Review) Identifier Messages ................................................................12-3
Command: Select ID-Triggered Macros ..................................................................................12-4
Command: Select ID Message Interval ...................................................................................12-5
Command: Select ID Pending Interval ....................................................................................12-6
Command: Reset Initial ID Message To Normal .....................................................................12-7
Command: Send Initial ID Message ........................................................................................12-8
Command: Select Programmable Tail Messages for Tx1 ......................................................12-9
Command: Select/Review Initial and Normal ID Tail Message .............................................12-10
Command: Enable/Disable ID Messages During Autopatch .................................................12-11
Links ................................................................. 13-1
Command: Enable/Disable Path .............................................................................................13-2
Command: Select Audio Routing Priority ................................................................................13-3
Command: Select Path Access Mode .....................................................................................13-4