Scanlab RTC 5 PC Interface Board - Page 562

RTC
®
5 PC Interface Board
Rev. 1.9 e
10 Commands And Functions
562
innovators for industry
Ctrl Command get_xyz_pos
Support status This RTC
®
2/RTC
®
3/RTC
®
4 command is not supported by the RTC
®
5.
RTC
®
4  RTC
®
5Replaced by get_value (see page 291)
List Command home_jump
Support status This RTC
®
2 command is not supported by the RTC
®
5.
Replaced by home_position (see page 298), the “home jump” is automatically executed.
List Command laser_on
Support status This RTC
®
2 command is not supported by the RTC
®
5.
Replaced by laser_on_list (see page 311)
Ctrl Command load_cor
Support status This RTC
®
2 command is not supported by the RTC
®
5.
Replaced by load_correction_file (see page 328)
Ctrl Command load_pro
Support status This RTC
®
2 command is not supported by the RTC
®
5.
Replaced by load_program_file (see page 340)
List Command pola_abs, polb_abs, polc_abs
Support status These RTC
®
2 commands are not supported by the RTC
®
5.
Replaced by mark_abs (see page 349)
Ctrl Command read_pixel_ad
Support status This RTC
®
2/RTC
®
3/RTC
®
4 command is not supported by the RTC
®
5.
RTC
®
4  RTC
®
5 There is no equivalent command for the RTC
®
5.
Ctrl Command rtc3_count_cards / rtc4_count_cards
Support status This RTC
®
3/RTC
®
4 commands are not supported by the RTC
®
5.
Replaced by rtc5_count_cards (see page 396)