Scanlab RTC 5 PC Interface Board - Page 563

RTC
®
5 PC Interface Board
Rev. 1.9 e
10 Commands And Functions
563
innovators for industry
Ctrl Command select_list
Support status This RTC
®
2/RTC
®
3/RTC
®
4 command is not supported by the RTC
®
5.
RTC
®
4  RTC
®
5 select_list(0) can be replaced by set_extstartpos(0), select_list(1) by
set_extstartpos(
Mem1 ). Thereby, Mem1 is the memory size of “List 1” (and the absolute start
address of “List 2”). After initialization (with load_program_file),
Mem1 is 4000, otherwise
as set via config_list.
Mem1 can be determined (e.g. after a board changed “ownership”)
via set_start_list_2 and get_input_pointer.
Ctrl Command set_base
Support status This RTC
®
2 command is not supported by the RTC
®
5.
Replaced by There is no equivalent command for the RTC
®
5 (because it is a plug-and-play board
whose base address is automatically set).
Ctrl Command set_co2_standby
Support status This RTC
®
2 command is not supported by the RTC
®
5.
Replaced by set_standby (see page 488)
List Command set_co2_standby_list
Support status This RTC
®
2 command is not supported by the RTC
®
5.
Replaced by set_standby_list (see page 489)
List Command set_delays
Support status This RTC
®
2 command is not supported by the RTC
®
5.
Replaced by set_laser_delays (page 442), set_scanner_delays (page 475)
List Command set_encoder_values
Support status This RTC
®
2 command is not supported by the RTC
®
5.
Replaced by set_fly_x (page 429), set_fly_y (page 431)
Ctrl Command set_gain
Support status This RTC
®
2 command is not supported by the RTC
®
5.
Replaced by set_matrix (page 449), set_offset (page 463)
Ctrl Command set_list_mode
Support status This RTC
®
3/RTC
®
4 command is not supported by the RTC
®
5.
RTC
®
4  RTC
®
5 See "Circular Queue Mode", page 82.