Scanlab RTC 5 PC Interface Board - Page 565

RTC
®
5 PC Interface Board
Rev. 1.9 e
10 Commands And Functions
565
innovators for industry
Ctrl Command z_out
Support status This RTC
®
3/RTC
®
4 command is not supported by the RTC
®
5.
RTC
®
4  RTC
®
5 For setting the Z value in a 3-axis scan system, the command set_defocus (see page 414)
can be used (only together with an RTC
®
5 with enabled 3D option). After
load_z_table(0.0, 1.0, 0.0), set_defocus(
Z ) has the same effect as z_out( Z ) (also see
set_offset_xyz).
List Command z_out_list
Support status This RTC
®
3/RTC
®
4 command is not supported by the RTC
®
5.
RTC
®
4  RTC
®
5After load_z_table(0.0, 1.0, 0.0), set_defocus_list( Z ) has the same effect as z_out_list( Z )
(also see set_offset_xyz_list).