RTC
®
5 PC Interface Board
Rev. 1.9 e
18 Revision History
613
Changes from revision 1.2 to revision 1.3
Page Name of section / command Change
52 "McBSP Interface" Changes and additions (as of version OUT 526):
• Stagnation of data transmission no longer occurs.
• Data transmission for online positioning
84 "Matching of Short-Command
Counts (as of Version DLL 523,
OUT 524)"
Added
96 chapter 7.1.3 "Marking Points" Added
102 Notes in section "Mark Delay" as of RTC5OUT.out version 526: changed behavior of timed
mark or arc commands with zero spacial length (also see
notes in chapter 8.10 "Timed Vector and Arc Commands",
page 198)
107 Automatic Delay Adjustments Change (as of version DLL 522, OUT 522, RBF 517):
• in section (1): If LaserOff overlaps LaserOn, then the LaserOff
delay still gets automatically extended, but only so that the laser
control signals remain on for 0.5 µs (instead of 10 µs).
• in section (2): If a LaserOff delay expires and simultaneously a
LaserOn delay should again be set, then an additional scanner
delay (of 10 µs) will no longer be inserted.
123 Notes in section Assigning Loaded
Correction Tables
Changed (as of version DLL 521, OUT 521):
load_correction_file automatically calls select_cor_table
after loading a correction table.
124 Correction File Header Changed: Parameter 15 (get_head_para, get_table_para)
is 2.0 (instead of 1.0) for ’field size clipped’.
165 chapter 8.3 "Online Positioning" Added
216 chapter 9.3.4 Added (as of version OUT 526): online positioning
230,
231
apply_mcbsp command and
apply_mcbsp_list command
Added
275,
276
get_mcbsp command and
get_mcbsp_list command
Change (as of version OUT 526): see “Version info” in the
command description
328 load_correction_file command Changed (as of version DLL 521, OUT 521):
load_correction_file automatically calls select_cor_table
after loading a correction table.
370 move_to command Added
375 para_laser_on_pulses_list
command
Added
388 read_mcbsp command Added
416 set_dsp_mode command Added
427…
432
set_fly_rot_pos, set_fly_x_pos and
set_fly_y_pos
Added (as of version OUT 526): can’t be used simultaneously
with online positioning
457…
459
set_mcbsp_rot,
set_mcbsp_rot_list,
set_mcbsp_x, set_mcbsp_x_list,
set_mcbsp_y, set_mcbsp_y_list
Added
To Next Page
Loading...
