Scanlab RTC 5 PC Interface Board - Page 622

RTC
®
5 PC Interface Board
Rev. 1.9 e
18 Revision History
622
innovators for industry
Changes from revision 1.8 to revision 1.9
Page Name of section / command Change
150 chapter 7.5.2 "Marking Serial
Numbers"
Expanded (with version DLL 537, OUT 537): Serial number
marking now with selectable serial-number-sets
167 chapter 8.4 "Wobbel Mode" Expanded: specify direction of motion and “freely definable
wobbel shapes”
168 chapter 8.4.1 "Wobbel Shapes –
Important Notes on Choosing
Appropriate Parameter Values"
Added
181 chapter "Correction via McBSP
Interface with Enhanced McBSP
Input"
Processing-on-the-fly correction in Z direction and laser
power variation is now possible
240 clear_fly_overflow command Changed with version DLL 531, OUT 532: bits #4, 5
242 config_laser_signals_list command Added (with version DLL 537, OUT 537)
259 fly_return_z command Added (with version DLL 531, OUT 532)
271 get_list_serial command Added (with version DLL 537, OUT 537)
301 if_fly_z_overflow command Added (with version DLL 531, OUT 532)
303 if_not_fly_z_overflow command Added (with version DLL 531, OUT 532)
340 load_program_file command Expanded (with version DLL 537, OUT 537): PCI error now
has its own error code 16
382 range_checking command Added (with version DLL 537, OUT 537)
389 read_multi_mcbsp command Added (with version DLL 537, OUT 537)
404,
404
select_serial_set command,
select_serial_set_list command
Added (with version DLL 537, OUT 537)
477 set_serial_step_list command Added (with version DLL 537, OUT 537)
425 set_fly_limits_z command Added (with version DLL 531, OUT 532)
459 set_multi_mcbsp_in command Added (with version DLL 537, OUT 537)
461 set_multi_mcbsp_in_list command Added (with version DLL 537, OUT 537)
481 set_sky_writing_para command Changed parameter
Timelag (with version DLL 537,
OUT 537)
503 set_wobbel_control command Added (with version DLL 537, OUT 537)
504 set_wobbel_direction command Added (with version DLL 537, OUT 537)
505 set_wobbel_mode command Changed with version DLL 537, OUT 537:
Mode s > 0
507 set_wobbel_offset command Added (with version DLL 537, OUT 537)
507 set_wobbel_vector command Added (with version DLL 537, OUT 537)