Scanlab RTC 5 PC Interface Board - Page 621

RTC
®
5 PC Interface Board
Rev. 1.9 e
18 Revision History
621
innovators for industry
343 load_stretch_table command Added (with version DLL 536, OUT 536)
366 micro_vector_abs command,
micro_vector_rel command
Changed (version DLL 536, OUT 536):
LasOn, LasOff < 2
15
367 micro_vector_abs_3d command,
micro_vector_rel_3d command
Added (version DLL 536, OUT 536)
380 park_position command,
park_return command
Added (version DLL 536, OUT 536)
400 select_cor_table command,
select_cor_table_list command
Changed (with version DLL 533, OUT 534): value range of
parameters
416 set_delay_mode_list command Added (with version DLL 536, OUT 536)
418 set_encoder_speed command,
set_encoder_speed_ctrl command
Changed (with version DLL 536, OUT 536):
EncoderNo = 2 and 3
424 set_fly_2d command Added (version DLL 536, OUT 536)
440 set_laser_control command Changed (with version DLL 536, OUT 536): bit#28
449 set_matrix command Changed (version DLL 536, OUT 536):
HeadNo = 4
463 set_offset command,
set_offset_xyz command
Changed (version DLL 536, OUT 536):
HeadNo = 4
468 set_pixel_line_3d command Added (with version DLL 536, OUT 536)
485 set_softstart_level_list command Added (with version DLL 536, OUT 536)
487 set_softstart_mode_list command Added (with version DLL 536, OUT 536)
493 set_trigger command Changed (with version DLL 536, OUT 536):
Signal1 ,
Signal2 = 43 and 44
497 set_trigger4 command Added (with version DLL 536, OUT 536)
542 timed_para_jump_abs_3d,
timed_para_jump_rel_3d,
timed_para_mark_abs_3d,
timed_para_mark_rel_3d
commands
Corrected: These commands are list multi-commands
(instead of normal list commands)
554 wait_for_encoder_in_range
command
Added (version DLL 536, OUT 536)