Scanlab RTC 5 PC Interface Board - Page 620

RTC
®
5 PC Interface Board
Rev. 1.9 e
18 Revision History
620
innovators for industry
Page Name of section / command Change
82 chapter 6.5.5 "Loops" Chapter added (version DLL 536, OUT 536)
128 chapter 7.4.1 "Enabling, Activating
and Switching Laser Control Signals"
Corrected: The laser output ports (LASERON, LASER1 and
LASER2) will also enter the (high impedance) tristate mode
if the laser control signals are subsequently disabled via a
command (also see disable_laser, pause_list and
set_laser_control(bit#2 = 1)).
149 chapter 7.4.10 "Output
Synchronization"
Notes changed (version RBF 527)
158 "Notes on Loading Determined Jump
Delay Values" (chapter 8.1.5 "Jump
Mode")
Corrected: the maximum value of the Length parameter for
jump delay tables is 1048576.0 (instead of 524288.0).
170 chapter 8.5 "Using Several Different
Correction Tables"
Changed (version DLL 533, OUT 534): up to 4 correction files
can be loaded
176 chapter 8.6.5 "Enhanced 3D
Correction"
Chapter added (version DLL 536, OUT 536)
177 chapter 8.7 "Processing-on-the-fly
(Optional)"
Changed (version DLL 536, OUT 536):
• New: section Overview
•New: chapter 8.7.4 "Compensation of 2D Motions" (incl.
the sections 2D Encoder Compensation for XY Stages and
Coordinate Transformations in the Virtual Image Field)
• Revised: chapter 8.7.6 "Virtual Image Field"
•Extended: chapter 8.7.7 "Synchronization of Processing-
on-the-fly Applications"
•New: chapter 8.7.8 "Encoder Resets"
218 "List Multi-Commands" Added
228 activate_fly_2d command,
activate_fly_xy command
Added (version DLL 536, OUT 536)
264 get_fly_2d_offset command Added (version DLL 536, OUT 536)
273 get_marking_info command Changed (version DLL 536, OUT 536): bit #9
285 get_table_para command Changed (with version DLL 533, OUT 534): value range of
TableNo
291 get_value command,
get_values command
Changed (with version DLL 536, OUT 536): additional
selectable data signals (
Signal = 43 and 44)
294 get_waveform command Changed (with version DLL 536, OUT 536):
Channel = 3 and 4
301 if_not_activated command Added (version DLL 536, OUT 536)
305 init_fly_2d command Added (version DLL 536, OUT 536)
323 list_repeat command,
list_until command
Added (with version DLL 536, OUT 536)
328 load_correction_file command Changed (with version DLL 533, OUT 534): value range of
No
(up to 4 correction files can be loaded)
333 load_fly_2d_table command Added (version DLL 536, OUT 536)