Siemens RUGGEDCOM ROS v4.3 - Adding an IP Gateway

RUGGEDCOM ROS
User Guide
Chapter 3
Device Management
Adding an IP Gateway 89
Figure41:IP Gateways Table
If IP gateways have not been configured, add IP gateways as needed. For more information, refer to
Section3.8.2, “Adding an IP Gateway” .
Section3.8.2
Adding an IP Gateway
To add an IP gateway, do the following:
1. Navigate to Administration» Configure IP Gateways . The IP Gateways table appears.
1
Figure42:IP Gateways Table
1.InsertRecord
2. Click InsertRecord. The IP Gateways form appears.