Siemens RUGGEDCOM ROS v4.3 - Ethernet Port Configuration, Statistics, and Security

RUGGEDCOM ROS
User Guide
Chapter 3
Device Management
Managing Ethernet Ports 65
75
6
4
3
2
1
Figure19:Remote Syslog Server Form
1.IP Address Box 2.UDP Port Box 3.Facility Box 4.Severity Box 5.Apply Button 6.Delete Button 7.Reload Button
3. Click Delete.
Section3.6
Managing Ethernet Ports
The following section describes how to set up and manage Ethernet ports.
NOTE
For information about configuring remote monitoring for Ethernet ports, refer to Section3.10,
“Managing Remote Monitoring” .
CONTENTS
• Section3.6.1, “Controller Protection Through Link Fault Indication (LFI)”
• Section3.6.2, “Viewing the Status of Ethernet Ports”
• Section3.6.3, “Viewing Statistics for All Ethernet Ports”
• Section3.6.4, “Viewing Statistics for Specific Ethernet Ports”
• Section3.6.5, “Clearing Statistics for Specific Ethernet Ports”
• Section3.6.6, “Configuring an Ethernet Port”
• Section3.6.7, “Configuring Port Rate Limiting”
• Section3.6.8, “Configuring Port Mirroring”
• Section3.6.9, “Configuring Link Detection”
• Section3.6.10, “Detecting Cable Faults”