Siemens RUGGEDCOM ROS v4.3 - Clearing Local Logs; Configuring the Local System Log

Chapter 3
Device Management
RUGGEDCOM ROS
User Guide
60 Clearing Local Logs
Section3.5.2
Clearing Local Logs
To clear both the local crash and system logs, log in to the CLI shell and type:
clearlogs
To clear only the local system log, log in to the Web interface and do the following:
1. Navigate to Diagnostics» Clear System Log . The Clear System Log form appears.
1
Figure12:Clear System Log Form
1.Confirm Button
2. Click Confirm.
Section3.5.3
Configuring the Local System Log
To configure the severity level for the local system log, do the following:
NOTE
For maximum reliability, use remote logging. For more information, refer to Section3.5.4, “Managing
Remote Logging” .
1. Navigate to Administration» Configure Syslog» Configure Local Syslog . The Local Syslog form appears.
32
1
Figure13:Local Syslog Form
1.Local Syslog Level 2.Apply Button 3.Reload Button
2. Configure the following parameter(s) as required: