RUGGEDCOM ROS
User Guide
Chapter 3
Device Management
Deleting an RMON Alarm 101
Parameter Description
The index of the event that is used when a falling threshold is
crossed. If there is no corresponding entryl in the Event Table,
then no association exists. In particular, if this value is zero, no
associated event will be generated.
Falling Event Synopsis:  0 to 65535
Default:  0
The index of the event that is used when a rising threshold is
crossed. If there is no corresponding entryl in the Event Table,
then no association exists. In particular, if this value is zero, no
associated event will be generated.
Owner Synopsis:  Any 127 characters
Default:  Monitor
The owner of this record. It is suggested to start this string
withword 'monitor'.
4. Click Apply.
Section3.10.2.3
Deleting an RMON Alarm
To delete an RMON alarm, do the following:
1. Navigate to Ethernet Stats» Configure RMON Alarms . The RMON Alarms table appears.
Figure56:RMON Alarms Table
2. Select the alarm from the table. The RMON Alarms form appears.
To Next Page
Loading...
Need help?
General
