Siemens RUGGEDCOM ROS v4.3 User Manual

RUGGEDCOM ROS
User Guide
Chapter 5
Setup and Configuration
Configuring STP Globally 163
6. Configure the Port Cost and Priority per Port for each MSTI. For more information, refer to Section5.2.9.5,
“Configuring an MSTI for an Ethernet Port” .
7. Set the STP Protocol Version to MSTP and enable STP. For more information, refer to Section5.2.4,
“Configuring STP Globally”
Section5.2.4
Configuring STP Globally
To configure global settings for the Spanning Tree Protocol (STP), do the following:
1. Navigate to Spanning Tree» Configure Bridge RSTP Parameters . The Bridge RSTP Parameters form
appears.
9
10
2
3
4
5
6
7
8
1
Figure94:Bridge RSTP Parameters Form
1.State Options 2.Version Support List 3.Bridge Priority List 4.Hello Time Box 5.Max Age Time Box 6.Transmit Count
Box 7.Forward Delay Box 8.Max Hops Box 9.Apply Button 10.Reload Button
2. Configure the following parameter(s) as required:
Parameter Description
State Synopsis:  { Disabled, Enabled }
Default:  Enabled
Enable STP/RSTP/MSTP for the bridge globally. Note that STP/RSTP/
MSTP is enabled on a port when it is enabled globally and along
with enabling per port setting.
Version Support Synopsis:  { STP, RSTP, MSTP }
Default:  RSTP
Selects the version of Spanning Tree Protocol to support, either
only STP or Rapid STP or Multiple STP.
Bridge Priority Synopsis:  { 0, 4096, 8192, 12288, 16384, 20480, 24576,
28672, 32768, 36864, 40960, 45056, 49152, 53248, 57344,
61440 }
Default:  32768

Siemens RUGGEDCOM ROS v4.3 Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROS v4.3
Category	Wireless Router
Language	English