Siemens RUGGEDCOM ROS v4.3 User Manual

RUGGEDCOM ROS
User Guide
Chapter 3
Device Management
Adding a Remote Syslog Server 63
Section3.5.4.3
Adding a Remote Syslog Server
RUGGEDCOM ROS supports up to 5 remote syslog servers (or collectors). Similar to the local system log, a remote
system log server can be configured to log information at a specific severity level. Only messages of a severity
level equal to or greater than the specified severity level are written to the log.
To add a remote syslog server to the list of known servers, do the following:
1. Navigate to Administration» Configure Syslog» Configure Remote Syslog Server . The Remote Syslog
Server table appears.
1
Figure16:Remote Syslog Server Table
1.InsertRecord
2. Click InsertRecord. The Remote Syslog Server form appears.
75
6
4
3
2
1
Figure17:Remote Syslog Server Form
1.IP Address Box 2.UDP Port Box 3.Facility Box 4.Severity Box 5.Apply Button 6.Delete Button 7.Reload Button
3. Configure the following parameter(s) as required:
Parameter Description
IP Address Synopsis:  ###.###.###.### where ### ranges from 0 to 255
Syslog server IP Address.
UDP Port Synopsis:  1025 to 65535 or { 514 }

Siemens RUGGEDCOM ROS v4.3 Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROS v4.3
Category	Wireless Router
Language	English