Siemens RUGGEDCOM ROS v4.3 - Adding an RMON Event; Viewing a List of RMON Events

RUGGEDCOM ROS
User Guide
Chapter 3
Device Management
Viewing a List of RMON Events 103
• Section3.10.3.3, “Deleting an RMON Event”
Section3.10.3.1
Viewing a List of RMON Events
To view a list of RMON events, navigate to Ethernet Stats» Configure RMON Events . The RMON Events table
appears.
Figure58:RMON Events Table
If events have not been configured, add events as needed. For more information, refer to Section3.10.3.2,
“Adding an RMON Event” .
Section3.10.3.2
Adding an RMON Event
To add an RMON alarm, do the following:
1. Navigate to Ethernet Stats» Configure RMON Events . The RMON Events table appears.
1
Figure59:RMON Events Table
1.InsertRecord
2. Click InsertRecord. The RMON Events form appears.