Chapter 3
Device Management
RUGGEDCOM ROS
User Guide
90 Deleting an IP Gateway
Figure43:IP Gateways
1.Destination Box 2.Subnet Box 3.Gateway Box 4.Apply Button 5.Delete Button 6.Reload Button
3. Configure the following parameter(s) as required:
Parameter Description
Destination Synopsis:  ###.###.###.### where ### ranges from 0 to 255
Specifies the IP address of destination network or host. For default
gateway, both the destination and subnet are 0.
Subnet Synopsis:  ###.###.###.### where ### ranges from 0 to 255
Specifies the destination IP subnet mask. For default gateway,
both the destination and subnet are 0.
Gateway Synopsis:  ###.###.###.### where ### ranges from 0 to 255
Specifies the gateway to be used to reach the destination.
4. Click Apply.
Section3.8.3
Deleting an IP Gateway
To delete an IP gateway configured on the device, do the following:
1. Navigate to Administration» Configure IP Gateways . The IP Gateways table appears.
Figure44:IP Gateways Table
To Next Page
Loading...
Need help?
General
