Siemens RUGGEDCOM ROS v4.3 - Deleting an IP Interface

RUGGEDCOM ROS
User Guide
Chapter 3
Device Management
Deleting an IP Interface 87
Parameter Description
Specifies the IP address of this device. An IP address is a 32-bit
number that is notated by using four numbers from 0 through
255, separated by periods. Only a unicast IP address is allowed,
which ranges from 1.0.0.0 to 233.255.255.255.
Subnet Synopsis:  ###.###.###.### where ### ranges from 0 to 255
Default:  255.255.255.0
Specifies the IP subnet mask of this device. An IP subnet mask
is a 32-bit number that is notated by using four numbers from
0 through 255, separated by periods. Typically, subnet mask
numbers use either 0 or 255 as values (e.g. 255.255.255.0) but
other numbers can appear.
IMPORTANT!
Each IP interface must have a unique network
address.
4. Click Apply.
Section3.7.3
Deleting an IP Interface
To delete an IP interface configured on the device, do the following:
1. Navigate to Administration» Configure IP Interfaces . The IP Interfaces table appears.
Figure39: IP Interfaces Table
2. Select the IP interface from the table. The IP Interfaces form appears.