Siemens RUGGEDCOM ROS v4.3 User Manual

Chapter 4
System Administration
RUGGEDCOM ROS
User Guide
128 Configuring the RADIUS Server
Attribute Value
EAP-Message
a
{ A message(s) received from the authenticating peer }
a
EAP-Message is an extension attribute for RADIUS, as defined by RFC 2869.
CONTENTS
• Section4.8.1.1, “Configuring the RADIUS Server”
• Section4.8.1.2, “Configuring the RADIUS Client”
Section4.8.1.1
Configuring the RADIUS Server
The Vendor-Specific attribute (or VSA) sent to the RADIUS server as part of the RADIUS request is used to
determine the access level from the RADIUS server. This attribute may be configured within the RADIUS server
with the following information:
Attribute Value
Vendor-Specific Vendor-ID: 15004
Format: String
Number: 2
Attribute: { Guest, Operator, Admin }
NOTE
If no access level is received in the response packet from the RADIUS server, access is denied.
Section4.8.1.2
Configuring the RADIUS Client
The RADIUS client can be configured to use two RADIUS servers: a primary server and a backup server. If the
primary server is unavailable, the device will automatically attempt to connect with the backup server.
NOTE
The RADIUS client uses the Password Authentication Protocol (PAP) to verify access.
To configure access to either the primary or backup RADIUS servers, do the following:
1. Navigate to Administration» Configure Security Server» Configure RADIUS Server . The RADIUS Server
table appears.

Siemens RUGGEDCOM ROS v4.3 Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROS v4.3
Category	Wireless Router
Language	English