Chapter 5
Setup and Configuration
RUGGEDCOM ROS
User Guide
236 Configuring Port Security
Parameter Description
MAC Address Synopsis: ##-##-##-##-##-## where ## ranges 0 to FF
Authorized MAC address learned by the switch.
VID Synopsis: 0 to 65535
VLAN Identifier of the VLAN upon which the MAC address operates.
Sticky Synopsis: { No, Yes }
This describes whether the authorized MAC address/Device can move
to another port or not:
• YES - authorized MAC address/Device cannot move to a different
switch port
• NO - authorized MAC address/Device may move to another switch
port
If a MAC address is not listed, do the following:
• Configure port security. For more information, refer to Section5.9.3, “Configuring Port Security” .
• Configure IEEE 802.1X. For more information, refer to Section5.9.4, “Configuring IEEE 802.1X” .
Section5.9.3
Configuring Port Security
To configure port security, do the following:
1. Navigate to Network Access Control» Port Security» Configure Ports Security . The Ports Security table
appears.
Figure167:Ports Security Table
2. Select an Ethernet port. The Ports Security form appears.
To Next Page
Loading...
Need help?
General
