Siemens RUGGEDCOM ROS v4.3 - Adding a Static Multicast Group; Viewing a List of Static Multicast Groups

Chapter 5
Setup and Configuration
RUGGEDCOM ROS
User Guide
230 Viewing a List of Static Multicast Groups
Section5.8.2.5
Viewing a List of Static Multicast Groups
To view a list of static multicast groups, navigate to Multicast Filtering» Configure Static Multicast Groups .
The Static Multicast Groups table appears.
Figure160:Static Multicast Groups Table
If a static multicast group is not listed, add the group. For more information, refer to Section5.8.2.6, “Adding a
Static Multicast Group” .
Section5.8.2.6
Adding a Static Multicast Group
To add a static multicast group from another device, do the following:
1. Navigate to Multicast Filtering» Configure Static Multicast Groups . The Static Multicast Groups table
appears.
1
Figure161:Static Multicast Groups Table
1.InsertRecord
2. Click InsertRecord. The Static Multicast Groups form appears.