EasyManuals Logo

Siemens RUGGEDCOM ROS v4.3 User Manual

Siemens RUGGEDCOM ROS v4.3
266 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #240 background imageLoading...
Page #240 background image
Chapter 5
Setup and Configuration
RUGGEDCOM ROS
User Guide
224 Managing GMRP
Parameter Description
NOTE
This parameter also affects the Group Membership
Interval (i.e. the group subscriber aging time),
therefore, it takes effect even in PASSIVE mode.
Router Ports Synopsis:  Comma-separated list of ports
Default:  None
This parameter specifies ports that connect to multicast routers. If
you do not configure known router ports, the switch may be able
to detect them, however it is advisable to pre-configure them.
Router Forwarding Synopsis:  { Off, On }
Default:  On
This parameter specifies whether multicast streams will be always
forwarded to multicast routers.
RSTP Flooding Synopsis:  { Off, On }
Default:  Off
This parameter specifies whether multicast streams will be
flooded out of all RSTP non-edge ports upon topology change
detection. Such flooding is desirable, if guaranteed multicast
stream delivery after topology change is most important.
4. Click Apply.
Section5.8.2
Managing GMRP
The GMRP is an application of the Generic Attribute Registration Protocol (GARP) that provides a Layer 2
mechanism for managing multicast group memberships in a bridged Layer 2 network. It allows Ethernet switches
and end stations to register and unregister membership in multicast groups with other switches on a LAN, and for
that information to be disseminated to all switches in the LAN that support Extended Filtering Services.
GMRP is an industry-standard protocol first defined in IEEE 802.1D-1998 and extended in IEEE 802.1Q-2005. GARP
was defined in IEEE 802.1D-1998 and updated in 802.1D-2004.
NOTE
GMRP provides similar functionality at Layer 2 to what IGMP provides at Layer 3.
CONTENTS
Section5.8.2.1, “GMRP Concepts”
Section5.8.2.2, “Viewing a Summary of Multicast Groups”
Section5.8.2.3, “Configuring GMRP Globally”
Section5.8.2.4, “Configuring GMRP for Specific Ethernet Ports”
Section5.8.2.5, “Viewing a List of Static Multicast Groups”
Section5.8.2.6, “Adding a Static Multicast Group”

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens RUGGEDCOM ROS v4.3 and is the answer not in the manual?

Siemens RUGGEDCOM ROS v4.3 Specifications

General IconGeneral
BrandSiemens
ModelRUGGEDCOM ROS v4.3
CategoryWireless Router
LanguageEnglish

Related product manuals