Siemens RUGGEDCOM ROS v4.3 - Managing Security-To-Group Mapping; Adding a Security-To-Group Map; Viewing a List of Security-To-Group Maps

RUGGEDCOM ROS
User Guide
Chapter 5
Setup and Configuration
Managing Security-to-Group Mapping 203
Section5.6.2
Managing Security-to-Group Mapping
The following section describes how to configure and manage security-to-group maps.
CONTENTS
• Section5.6.2.1, “Viewing a List of Security-to-Group Maps”
• Section5.6.2.2, “Adding a Security-to-Group Map”
• Section5.6.2.3, “Deleting a Security-to-Group Map”
Section5.6.2.1
Viewing a List of Security-to-Group Maps
To view a list of security-to-group maps configured on the device, navigate to Administration» Configure
SNMP» Configure SNMP Security to Group Maps . The SNMP Security to Group Maps table appears.
Figure133:SNMP Security to Group Maps Table
If security-to-group maps have not been configured, add maps as needed. For more information, refer to
Section5.6.2.2, “Adding a Security-to-Group Map” .
Section5.6.2.2
Adding a Security-to-Group Map
Multiple combinations of security models and groups can be mapped (up to a maximum of 32) for SNMP.
To add a security-to-group map, do the following:
1. Navigate to Administration» Configure SNMP» Configure SNMP Security to Group Maps . The SNMP
Security to Group Maps table appears.