Siemens RUGGEDCOM ROS v4.3 - Deleting a Security-To-Group Map; Managing SNMP Groups

RUGGEDCOM ROS
User Guide
Chapter 5
Setup and Configuration
Deleting a Security-to-Group Map 205
Section5.6.2.3
Deleting a Security-to-Group Map
To delete a security-to-group map, do the following:
1. Navigate to Administration» Configure SNMP» Configure SNMP Security to Group Maps . The SNMP
Security to Group Maps table appears.
Figure136:SNMP Security to Group Maps Table
2. Select the map from the table. The SNMP Security to Group Maps form appears.
64
5
3
2
1
Figure137:SNMP Security to Group Maps Form
1.Security Model Box 2.Name Box 3.Group Box 4.Apply Button 5.Delete Button 6.Reload Button
3. Click Delete.
Section5.6.3
Managing SNMP Groups
Multiple SNMP groups (up to a maximum of 32) can be configured to have access to SNMP.
CONTENTS
• Section5.6.3.1, “Viewing a List of SNMP Groups”
• Section5.6.3.2, “Adding an SNMP Group”