Siemens RUGGEDCOM ROS v4.3 - Managing SNMP Users; Viewing a List of SNMP Users

Chapter 5
Setup and Configuration
RUGGEDCOM ROS
User Guide
198 Managing SNMP Users
model. A combination of a security model and level will determine which security mechanism is employed when
handling an SNMP packet.
Before configuring SNMPv3, note the following:
• Each user belongs to a group
• A group defines the access policy for a set of users
• An access policy defines what SNMP objects can be accessed for (i.e. reading, writing and creating notifications)
• A group determines the list of notifications its users can receive
• A group also defines the security model and security level for its users
For SNMPv1 and SNMPv2c, a community string can be configured. The string is mapped to the group and access
level with a security name, which is configured as User Name.
CONTENTS
• Section5.6.1, “Managing SNMP Users”
• Section5.6.2, “Managing Security-to-Group Mapping”
• Section5.6.3, “Managing SNMP Groups”
Section5.6.1
Managing SNMP Users
The following section describes how to configure and manage SNMP users.
CONTENTS
• Section5.6.1.1, “Viewing a List of SNMP Users”
• Section5.6.1.2, “Adding an SNMP User”
• Section5.6.1.3, “Deleting an SNMP User”
Section5.6.1.1
Viewing a List of SNMP Users
To view a list of SNMP users configured on the device, navigate to Administration» Configure SNMP»
Configure SNMP Users . The SNMP Users table appears.