RUGGEDCOM ROS
User Guide
Chapter 5
Setup and Configuration
Deleting an SNMP User 201
Parameter Description
generated to trap receivers if request was received from this user,
but from any other IP address.If IP address is empty, traps can not
be generated to this user, but SNMP requests will be served for
this user from any IP address.
v1/v2c Community Synopsis:  Any 32 characters
The community string which is mapped by this user/security name
to the security group if security model is SNMPv1 or SNMPv2c. If
this string is left empty, it will be assumed to be equal to the same
as user name.
Auth Protocol Synopsis:  { noAuth, HMACMD5, HMACSHA }
Default:  noAuth
An indication of whether messages sent on behalf of this user to/
from SNMP engine, can be authenticated, and if so, the type of
authentication protocol which is used.
Priv Protocol Synopsis:  { noPriv, CBC-DES }
Default:  noPriv
An Indication of whether messages sent on behalf of this user to/
from SNMP engine can be protected from disclosure, and if so,
the type of privacy protocol which is used.
Auth Key Synopsis:  31 character ASCII string
The secret authentication key (password) that must be shared
with SNMP client. If the key is not an emtpy string, it must be at
least 6 characters long.
Confirm Auth Key Synopsis:  31 character ASCII string
The secret authentication key (password) that must be shared
with SNMP client. If the key is not an emtpy string, it must be at
least 6 characters long.
Priv Key Synopsis:  31 character ASCII string
The secret encription key (password) that must be shared with
SNMP client. If the key is not an emtpy string, it must be at least 6
characters long.
Confirm Priv Key Synopsis:  31 character ASCII string
The secret encription key (password) that must be shared with
SNMP client. If the key is not an emtpy string, it must be at least 6
characters long.
4. Click Apply.
Section5.6.1.3
Deleting an SNMP User
To delete an SNMP user, do the following:
1. Navigate to Administration» Configure SNMP» Configure SNMP Users . The SNMP Users table appears.
To Next Page
Loading...
Need help?
General
