Chapter 4 ā Configuring the Library Backing Up the Library Configuration
December 2019 User GuideāSpectra T200, T380, and T680 Libraries
146
4. Select the Save Library Configuration utility. The screen refreshes to
show the details for the utility.
5. Use the Select the destination drop-down list to select where you want
to save the file.
Note: Do not use the check boxes at the top of the screen. They act on
the Utility Results message, not the configuration file.
6. Click Run Utility.
After a brief delay, the Utility Results screen displays, showing that the
configuration file was either saved or sent.
7. Confirm that the backup was successful, as described in Verify the
Configuration Backup.
Verify the Configuration Backup
After creating a backup of your library configuration, use one of the
methods described in the following sections to verify that the backup was
successful as soon as possible after you create it.
Figure 72 The Save Library Configuration utility.
Select... To.. .
save library
configuration to
USB
Save the library configuration file to the USB device connected to a USB port on
the LCM. The backup file is stored in a folder called
SavedConfigs\<date-time>, where <date-time> is the time stamp for
when the backup was created. The folder contains multiple configuration files
with the format cnnnnnn.cfg, where n is a number between 0 and 9.
mail library
configuration to
[mail recipient]
Send the library configuration file as a zip file attached to an email addressed to
a previously configured mail recipient (see Configure Mail Users on page 115).
Note: Do not mail the file to autosupport@spectralogic.com unless Spectra Logic
Technical Support specifically requested the file for troubleshooting.
To Next Page
Loading...
